13
User Instructions
Customer Helpline 0345 257 7271
Flame safety device:
Hob Burners
Hobs equipped with a flame failure device provide
security in case of accidentally extinguished
flames. If such a case occurs, the device will block
the burners gas lines and will avoid any
accumulation of unburned gas. Wait 90 seconds
before reigniting an extinguished gas burner
product
Regardless of the model of your appliance, all
oven burners are equipped with a gas safety
device. For this reason, during ignition, keep the
oven knob pressed until you see stable flames. If
the flames are cut out after you release the knob,
repeat the procedure again. If the oven burner
does not ignite after you keep the burner knob
pressed for 30 seconds, open the oven door and
do not attempt re-ignition for at least 90 seconds.
When oven flames go out accidentally, repeat the
same procedure
.
* This is an obligation for countrys that follow EU
Directives. If your country doesn't follow EU
Directives,your
may not be equipped with
flame safety device.
Oven / Grill Burners
.
Control of the hob burners
The knob has 3 positions: Off (0), maximum (big
flame symbol) and minimum (small flame symbol).
After you ignite the burner in maximum position;
you can adjust the flame length between maximum
and min. positions. Do not operate the burners
when the knob position is between maximum and
off positions.
After the ignition, check the flames visually. If you
see a yellow tip, lifted or unstable flames; turn the
gas flow off, and check the assembly of burner
caps and crowns (Figure 17). Also, make sure that
no liquid has flown into the burner cups. If the
burner flame goes out accidentally, turn the burner
off, ventilate the kitchen with fresh air, and do not
attempt re-ignition for 90 sec.
When turning the hob off, turn the knob in the
clockwise direction so that the knob shows "0"
position or the marker on the knob points
upwards.
Figure 17
Cap
Crown
Spark
Plug
Burner
Cup
MAX. position
OFF position
MIN. position
Figure 16
MODULATE