Customer Helpline 0345 257 7271
Cleaning And Maintenance
Removal of oven door
Saddle
bracket
Recessed
form
1
2
3
To remove the oven door;
• Open the oven door(1).
• Open the saddle bracket (with aid of screwdriver,
tongs etc.) up to end position(2).
• Close the door till it almost reaches the full closed
rd
position as shown in 3 figure and remove the door by
pulling it towards yourself.
NOTE: To re-assemble the door follow the opposite
rules of removal.
Please pay attention that the recessed forms
should be positioned properly on the hinge counterparts
nd
as shown on 2 figure.
Cleaning of Gas Cooker - Hob Part
• Lift up the pan supports, caps and crowns of
hob burners.
• Wipe and clean the back panel with a soapy
cloth.
• Wash the caps and crowns of hob burners and
rinse them. Do not leave them wet, immediately
dry them with paper cloth.
• After cleaning, make sure that you re-assemble
the parts correctly.
• Do not clean any part of the hob with a metal
sponge. It causes the surface be scratched.
• The pan support top surfaces may be
scratched in time due to usage. In this case,
these parts may get rusted and it is not a
production fault.
• During cleaning of the hob plate, make sure
that no water flows inside the burner cups, as
this may block the injectors.
Burner Caps:
Periodically, enameled pan support, enameled
covers, burner heads must be washed with soapy
warm water rinsed and dried. After drying them
thoroughly, replace them correctly.
Hob Surface
Enamelled Parts:
In order to keep them a new, it is necessary to
clean them frequently with mild warm soapy water
and then dry with cloth. Do not wash them while
hot and never use abrasive powders or abrasive
cleaning materials. Do not leave vinegar, coffee,
milk, salt, water, lemon, or tomato juice to remain
in contact with enameled parts for long periods of
time.
Stainless Steel:
Stainless steel parts must be cleaned frequently
with mildly warm soapy water and a soft sponge
and then dry with a soft cloth. Do not use abrasive
powders or abrasive cleaning metarials. Do not
leave vinegar, coffee, milk, salt, water, lemon or
tomato juice to remain in contact with stainless
steel parts long periods of time.
20