Installation
Transportation
Caution:
2 people are required to
unpack and handle the appliance, it is
recommended that gloves are worn.
y
The appliance should be transported only in
an upright position. Do not tilt the appliance
greater than 45
°
. The packaging as supplied
must be intact during transportation.
y
After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply
could result in damage to the appliance.
y
Do not move the appliance by pulling the door
or handle as it may damage your flooring and
wall coverings etc.
y
Empty any water in the drain tray before
moving.
y
Make sure that the defrost water pipe at the
back of the product is fixed to the plastic
evaporating pan on the top of the compressor,
to avoid defrost water spillage on the floor.
y
Ensure the supply cable is not caught under
the appliance during and after moving.
y
Carefully remove all packaging materials
including the foam base, dispose of correctly.
y
Ensure sufficient spacing is provided for the
appliance to be installed. Leave space on
both sides (15cm), back (20cm) and above the
appliance (30cm) to ensure proper ventilation.
y
Do not place the appliance near a heat source
or in direct sunlight.
y
Do not put any heavy objects on top of the
appliance. It will damage the appliance.
y
Do not install the appliance in moist and wet
place.
y
Adjust the feet at front to level the appliance.
It should be installed on a smooth surface to
avoid excessive vibration and noise.
y
Each appliance has a climate class (shown on
the rating plate) where it indicates the
temperature range of the appliance operation
in place. The appliance may not work properly
if it is left for a long period at a temperature
outside the specified range.
y
Refer to section “Care and Maintenance” to
prepare your appliance for use.
Climate Class
Amb. T. (
°
C)
Amb. T. (
°
F)
SN
10 ~ 32
°
C
50 ~ 90
°
F
N
16 ~ 32
°
C
61 ~ 90
°
F
ST
16 ~ 38
°
C
61 ~ 100
°
F
T
16 ~ 43
°
C
61 ~ 110
°
F
Installation
4
