Installation
Door Reverse
Warning:
Remove the main plug before
reversing the door. 2 people may be required to
reverse the door.
1. Remove the screws (1) holding the top panel
(2) to the unit. Remove the top panel.
2. Remove the two screws (3) holding the top
hinge (4) (right side) to the frame. Remove
the top hinge (4).
3. Lift the door off the middle hinge pin and
place it on a non-scratching surface.
4. Remove the two screws (5) holding the
middle hinge (6). Remove the middle hinge
(6).
5. Lift the lower door off the bottom hinge pin
and place it on a non-scratching surface.
6. Remove the two screws (7) holding the
bottom hinge (8). Remove the bottom hinge
(8).
7. Remove the left front leg (9) and transfer it to
the right side.
8. Before replacing the bottom hinge (8),
remove the hinge pin (10) and reverse the
direction of the hinge (8). Reassemble the
bottom hinge (8) on the left hand side using
the two screws (7).
9. Refit the hinge pin (10) into the bottom hinge
(8).
10. Lower the door onto the bottom hinge pin
(10).
11. While holding the lower door in the closed
position, reassemble the middle hinge (6) on
the left hand side using the two screws (5).
Do not tighten the screws (5) until the top of
the lower door is level with the counter top.
12. Before replacing the upper hinge (4), remove
the hinge pin (11) and reverse the direction of
the hinge (4).Refit the hinge pin (11) into the
upper hinge (4).
13. Lower the upper door onto the middle hinge
pin.
14. While holding the upper door in the closed
position, reassemble the upper hinge (4) on
the left hand side using the two screws (3).
Do not tighten the screws (3) until the top of
the upper door is level with the counter top.
15. Refit the top panel (2) using the screws (1).
5
