Bush BETAW50B, Instruction Manual

Care and maintenance

Looking after your appliance

Care and maintenance

26

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the 

Troubleshooting

 section of these instructions, 

Cleaning

WARNING! Isolate the power supply to the appliance and make sure that the cooker is cool.
Before cleaning your cooker or performing maintenance, make sure that the cooking mode selection knob and the 
cooking temperature selection knob is set to ‘OFF’. To extend the life of your cooker, it must be cleaned frequently.
The inside of the cooker should preferable be cleaned immediately after use, when it is still warm (but not hot), with 
warm water and soap. The soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive 
detergents, scourers, acidic cleaners such as lime scale remover, etc, as these could damage the enamel, and can 
result in development of rust and corrosion. If stains are particularly tough to remove, use cleaners specifically 
recommended to clean cookers and follow the instructions provided with the cleaner. 

Never use steam cleaner for cleaning inside the cooker.

Do not clean using caustic creams, abrasive cleaning powders, thick wire wool or hard tools. Enamelled parts of the 
cooker can be damaged if excess cleaning liquids are not immediately removed.

After cleaning the interior parts of the cooker with a soapy cloth, rinse it and then dry thoroughly with a soft cloth.

Clean the glass surfaces with special glass cleaning agents.

Never use flammable agents like acid, thinner or petrol when cleaning your appliance.

Do not clean your cooker with a steam cleaner.

Do not wash any part of your cooker in a dishwasher.

Enamelled Parts:
In order to keep enamelled parts as new, it is necessary to clean them frequently with mild warm soapy water and 
then dry with a cloth. Do not wash them while hot and never use abrasive powders or abrasive cleaning materials. Do 
not leave anything spilled onto enamelled parts for long periods of time.

Stainless Steel:
Stainless steel parts must be cleaned frequently with mildly warm soapy water and a soft sponge and then dried with 
a soft cloth. Do not use abrasive powders or abrasive cleaning materials. Do not leave anything spilled onto stainless 
steel parts for long periods of time.