Bush BGC60SB, Instruction Manual

Functions

Simple everyday use

Functions

26

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the 

Troubleshooting

 section of these instructions, 

Use of gas burners

Ignition of the burners

The position symbol above each control knob indicates 
the burner that the knob controls.

Manual ignition of the gas burners

If your appliance is not equipped with an ignition aid, or 
in case there is a failure in the electric network, follow 
the procedures listed below.

For hob burners: 

Push in the knob of the burner you 

wish to ignite and keep it pressed while turning it anti-
clockwise until the knob is in the ‘maximum’ position. 
Continue pressing the knob and hold a lit match, taper 
or other manual aid to the upper circumference of the 
burner. Move the ignition source away from the burner 
as soon as you see a stable flame.

For oven burner: 

Push in and turn the oven control 

knob anti-clockwise until the knob is in the ‘maximum’ 
position. Hold a lit match, taper or other manual aid to 
the ignition hole that is located on the front left corner 
of the burner. Move the ignition source away as soon 
as you see a stable flame.

For grill burner:

  Push in and turn the grill control knob 

clockwise until the marker on the knob points at the 
grill sign. Continue pressing the knob and hold a lit 
match, taper or other manual aid to the holes on the 
burner. Move the ignition source away from the burner 
as soon as you see a stable flame.

Electrical ignition by control knob

Push in the knob of the burner you wish to ignite and 
keep it pressed while turning it anti-clockwise until the 
knob is in the 90 degrees position.The microswitch 
under the knob will create sparks through the spark 
plug for as long as the control knob is pressed. Press 
the knob until you see a stable flame on the burner.

Flame safety device

Hob burners

Hobs equipped with a flame failure device provide 
security in case of an accidentally extinguished flame. 
If such a case occurs, the device will block the burners 
gas lines and will avoid any accumulation of unburned 
gas. Wait 90 seconds before re-igniting an extinguished 
gas burner.

Oven / Grill (If available) Burners

Regardless of the model of your appliance, all oven 
burners are equipped with a gas safety device. For 
this reason, during ignition, keep the oven knob 
pressed until you see stable flames. If the flames are 
cut out after you release the knob, repeat the ignition 
procedure. If the oven burner does not ignite after 
you keep the burner knob pressed for 30 seconds, 
open the oven door and do not attempt re-ignition 
for at least 90 seconds. If the oven flames go out 
accidentally, repeat the same procedure.

Hob controls

Hob burner

The knob has 3 positions: off (0), maximum (big flame 
symbol) and minimum (small flame symbol). Ignite 
the burner with the knob in the ‘maximum’ position; 
you can then adjust the flame length between the 
‘maximum’ and ‘minimum’ positions. Do not operate 
the burners when the knob is between the ‘maximum’ 
and ‘off’ positions.

OFF position

MAX position

MIN. position

MODULATE

After ignition, visually check the flames. If you see 
a yellow tip, lifted or unstable flame, switch the gas 
flow off, then check the assembly of burner caps and 
crowns once they have cooled. Make sure there is 
no liquid in the burner caps. If the burner flames go