Page 9
User instructions
Troubleshooting
In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below .
If the problem persists, visit the technical support website: www .argos-support .co .uk
Problem
Reason(s)
Solution(s)
No power
• Power cable not connected to
wall socket
• Power socket is not switched on
• The power saving mode is
activated .
• Make sure the plug is connected
• Switch the power on
• See ’Mains connection’ page 5 for
details .
No sound when connected to
a home stereo system
• Volume is too low
• The RCA cables are not connected
correctly .
• The stereo system is not set to the
correct input mode .
• Increase the volume
• Check the connections .
• Check which input you connected the
RCA cables to and switch to that input
mode on your stereo system .
No sound when connected to
a computer
• The device was not recognised
when connected .
• The software playthorugh option
was not ticked .
• The recording level bar was not
clicked .
• Re-boot the computer and try again .
• See page 7 ‘Setting up the device on a
computer section 5’ for details .
• See page 7 ‘Setting the recording
levels section 2’ for details .
The start or stop position is
not accurate
• The tone arm alignment is not set
correctly .
• See page 6 for instructions on
alignment .
Recordings made through a
computer are distorted
• The input levels are too high
• Adjust the input levels . See page 7
‘Setting the recording levels’ .
The stylus is skating across
the record
• The counter weight is not set
correctly .
• Adjust the counterweight . See page 4
‘Installing the counter weight’ .
The record is playing too fast
or too slow .
• The pitch adjustment needs fine
tuning .
• Increase or decrease the pitch adjust
control . See page 5 ‘Pitch adjust’ .
Summary of Contents for CTT939
Page 1: ...Instruction Manual CTT939 ...
