9
Setting Remote Control Learning Keys
Step 2: Enter setting of learning mode.
Remote control
TV remote control
1~3cm
1.Press STUDY key until Red LED remainslit (for about 3 seconds)
2.Point Converter remote control to TV rem ote control directly, keep the distance about 1~3 cm.
Step 3: Set TV's remote power key
1. Press the "Power" key at TV's remote control to send signal to Converter remote control. The
LED light will flash till steady. Then press " Power " key at Converter remote control. It will
record the signal.
2.Now the Power key can turn on/off TV's power.
Step 4: Repeat setting of learning for the other keys
You can repeat Step 3 for setting of learning for the other keys at TV remote control, such as VOL+,
VOL-, CH+, CH-, and F1, F2 are reserved for any other keys you want to set up.
Note:
1. When you finish setting the learning
2. The learning function of this remote control may not support all types of TV sets, if you still
not control your TV after you have attempted the above steps, then this remote control
not support your TV or its remote control.
keys, press the STUDY key to leave the learning status,
and the LED light will turn off.
can
may
Step 1: Insert batteries as outlined previously.
RECALL
INFO
FA
V
TV/RADIO
TEXT
SUBT
TIMER
LANG
F1
F2
NC
F1
F2
Setting of Learning Keys
There are seven keys on the remote control for TV set, VOL+/-, CH+/-, POWER and two
customer design keys, F1/F2. All the other keys are for converter. Make sure that the
TV sets remote control is working properly, and then set the learning keys according
to the following steps:
Summary of Contents for DFTA13HD
Page 2: ......
Page 38: ...www bushaustralia com au...
