Bush FREEVIEWHD DV3 T2, Instruction Manual

Using your Set top box

Let’s get started

Using your Set top box

22

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the 

Troubleshooting

Installation

Auto scan

This operation will erase the channel database and 
any customisation you have made using the channel 
organiser. All located channels will be added to a fresh 
database.

After Pressing the OK button you will be asked for the 
default password ‘0000’ to allow access to the scan 
function.

You will then be asked if your sure you wish to erase 
the channel database and perform the scan. Select ‘Yes’ 
and press the OK button.

While the set top box is scanning, any channels/ 
stations you where watching/ listening to will stop 
until the scan is complete.

When complete the installation menu will appear 
again. Press EXIT to resume viewing.

Smart retune

This operation will not erase the channel database and 
any customisation you have made using the channel 
organiser will remain. Any new channels located will be 
added to the existing database.

After Pressing the OK button you will be asked for the 
default password ‘0000’ before proceeding with the 
auto scan.

While the set top box is scanning, any channels/ 
stations you where watching/ listening to will stop 
until the scan is complete.

When complete the installation menu will appear 
again. Press EXIT to resume viewing.

Manual scan

When using the auto/ smart scan functions the 
operation can take some time to scan. The manual 
scan option allows you scan a specific part of the 
spectrum.

1. 

After Pressing the OK button you will be asked for 
the default password ‘0000’ before proceeding 
with the manual scan settings.

2. 

Use the      buttons to select the ‘Channel No’ 
from 21-69.

As you select each channel number the signal 
strength & quality bars will change.

3. 

Enter a frequency using the numeric buttons

4. 

Select ‘Network search’ On or Off.

5. 

And scan mode to ALL, FTA or SCRAMBLED.

6. 

Press the OK button to begin the scan from the 
data you entered.

7. 

Once complete you will be asked if you wish to 
save the located channels. Select YES and press 
the OK button.