Getting to know your TV
You’ll be up and running in no time
Getting to know your TV
16
If you require any technical guidance or
fi
nd that your TV is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
or online at
www.bush-support.co.uk
.
1
2
4
x M(
4x16
)
fi
g 1)
Place the TV set on a
fl
at and clean surface with the
panel facing downwards to avoid damage, then
fi
x the
stand feet shown.
fi
g 2)
Secure the stand feet to the underside of the TV set
using the screws provided.
Helpful advice for
fi
rst time stand installation
a) Ensure the cross head screw driver tip
fi
ts correctly into the head of the screw and that it is not too big or small.
b) Screw in all screws individually and partially before tightening all of the screws fully.
Stand installation
To complete the stand installation, you will require a cross head screw driver and the supplied screws.
L
R
4 x
3
4
1
2
L
R
Detaching the stand
To detach the stand, place the TV set on a
fl
at and clean surface with the panel facing downwards to avoid damage.
Please remove the
4
screws highlighted then remove the stand feet from the rear of the TV set.
4 x
3
4
1
2
L
R
BUS-MAN-0035 - 32+ models.indd Sec1:16
BUS-MAN-0035 - 32+ models.indd Sec1:16
20/05/2021 17:28:05
20/05/2021 17:28:05