Getting to know your TV
You’ll be up and running in no time
Getting to know your TV
18
If you require any technical guidance or
fi
nd that your TV is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
or online at
www.bush-support.co.uk
.
TV
fi
g 1
fi
g 2
Viewing angle
Viewing angle
INCORRECT
CORRECT
TV
Wall Mounting
IMPORTANT
: Before drilling any holes in the wall, ensure you are not drilling where there could be any electric
wires, water or gas pipes.
1
. Remove the four screws located at the back of the TV set.
2
. The wall mount can now be easily attached to the
mounting holes, located on the back of the TV, using the
same four screws removed.
For VESA wall mounting information please refer to the Technical Speci
fi
cation page.
IMPORTANT
: If wall mounting this TV, only use the screws already provided in the wall mounting holes. Using
other screws which are longer could cause irreparable damage to internal parts.
For optimum viewing, if wall mounting the TV higher than eye level, the TV should be tilted downwards so that the
TV’s screen is ‘face on’. See
fi
g 1 and 2 below.
BUS-MAN-0035 - 32+ models.indd Sec1:18
BUS-MAN-0035 - 32+ models.indd Sec1:18
20/05/2021 17:28:06
20/05/2021 17:28:06