For any help concerning set up and use of your TV please call the Customer Helpline: 0044 845 604 0105
18
Side AV Connections
You must use the supplied SIDE AV connection cable
for enabling SIDE AV connection.
1.
Plug single jack of the cable to the TV’s SIDE AV
socket.
2.
Insert your AV cable’s (not supplied) connectors into
the plural part of the SIDE AV connection cable (see
illustration below). Colours of the connected jacks
should match.
3.
To enable audio connection, use an audio cable.
Insert your device’s audio cable’s connectors into the
plural part of the
SIDE AV connection cable
. Colours
of the connected jacks should match (fig.
1)
.
4.
When the connection is made, switch to
SIDE AV
source.
Using a Conditional Access Module
IMPORTANT: Insert or remove the CI module only
when the TV is SWITCHED OFF.
In order to watch certain digital channels, a conditional
access module (CAM) can be necessary. This module
must be inserted in the CI slot of your TV.
1.
Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert those to the TV using the following
procedure.
2.
Insert the CAM and then the viewing card to the slot
that is located in the terminal cover at the rear side of
the TV.
3.
The CAM should be correctly inserted, it is impossible
to insert fully if reversed. The CAM or the TV terminal
may be damaged if the CAM is forcefully inserted.
4.
Connect the TV to the mains supply, switch on and
then wait for few moments until the card is activated.
5.
When no module is inserted, “
No Common Interface
module detected
” message appears on the screen.
You can refer to the module instruction manual for
details of the settings.
Connections
fig.1
CAM
module
fig.2
Camera
AV Connection
Cable (supplied)
AV Cable
(not supplied)
Headphone
SI
D
E
AV
