Other information
Helpful technical information
Other information
42
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Wall mounting your Micro
You can wall mount your Micro without its stand. You will need:
2 x rawl plugs of a type and size that are suitable for the wall that you will hang the Micro
on.
2 x screws that are the correct size for the rawl plugs. You will also need to check that the
screw heads fit and hold well into the wall mount points on the back of the Micro.
Notes:
• Make sure that the screws and rawl plugs you use are suitable for supporting the
Micro.
• To avoid damage to the Micro and personal injury, you should get a qualified person to
drill the fixing surface and fit the appropriate wall fixings.
• When drilling into walls, always check that there are no hidden wires or pipes etc.
• Before wall mounting your product, check the wall strength. If this is not clear, then
consult relevant qualified personnel.
• Take care not to allow the Micro to fall whilst attempting to hook it onto the screws
you have fitted to hang the product onto.
• You must remove the base stand from your Micro, before you attempt to wall mount
it. Press down on the clip on the top central part of the stand to remove it (if fitted).
1.
Align the Micro in your chosen location and use a
pencil to mark the drilling positions 120 mm apart.
2.
Drill the holes as marked in point 1.
Fig 7.
120 mm
Summary of Contents for WM2760DAB
