5
Loading Batteries
Turn the SyncFocus over, slide open the battery cover as indicated by the arrow, remove and set aside. Insert 2
AAA Alkaline or Lithium batteries into the compartment
(G)
in the direction indicated inside, then replace the
cover, sliding it back into place until it clicks.
Note: Rechargeable NiMh type batteries may also be used, but
some may not deliver adequate current to power the camera and display. AAA NiMh batteries with a current
rating of 850 mAh or higher are recommended.
Inserting An SD Card
The camera can store from about 15 (at 2660x1920 resolution and “Best” quality) up to over 100 photos in the
internal memory, depending on resolution and quality settings. To expand the available storage, you may
add an optional SD (Secure Digital) memory card, with 2GB or lower capacity.
The camera will not function if
a 4GB or higher capacity SD card is inserted.
Do not use “MMC” cards, which look similar to SD cards. The card
is inserted into the slot
(J)
on the back of the camera pod (
pull down the rubber cover flap-please refer to the
“Camera and Binocular Parts Guide” page
), label side up with the “notched” corner on the right as indicated by
the card icon above the slot.
Note: be sure the power is turned off before inserting or removing cards to prevent
possible loss of files or damage to the card.
A new card will not require formatting, but a card that has been
previously used in other devices (cameras, mp3 players, etc) should be formatted by the SyncFocus before
you start taking photos (
see the “Using the Review Menu” section for details
).
Note that formatting will erase all
files previously stored on the card, so be sure they have been downloaded and saved on your computer
first if you wish to keep them.
BASIC SETUP
