Bushranger BRV2600, Operator'S Manual

6 

Fuel Requirements:

•  Use only fresh, clean fuel. 

•  Use only fuel with an octane rating of 95 or 

higher. 

•  Mix all fuel with premium 2-cycles engine oil at 

a gasoline/oil ration of 25:1.

       CAUTION

Never attempt to mix fuel in the machine fuel 

tank. Always mix all fuels in a clean approved 

container. Some gasoline contains alcohol as 

an oxy genated. Oxy genated fuels may cause 

increased engine operating temperatures. Under 

certain conditions, alcohol-based fuels may also 

reduce the lubricating qualities of some mixing 

oils. Never use any fuel containing more than 

10% alcohol by volume.

Vacuum Bag

•  Unzip the bag and place  

the small end of the 

elbow tube through the 

hole at the opposite end. 

Pull the narrow end of the 

tube out of hole, until it is 

held firmly in place at the 

wider end (fig. 4). 

Attach the elbow tube to 

the machine and twist 

in place as per (fig. 5) 

then fit and tighten the 

securing screw. 

       IMPORTANT

Mix only enough fuel for your 

immediate needs. If fuel must 

be stored longer than 30 days, 

it should first be treated with a 

stabilizer or equivalent product.

       WARNING

•  Danger from rotating impeller. Stop the engine 

before installing or removing the machine 

tubes. Never perform any maintenance or 

assembly procedures on this machine while 

MIXING FUEL

Blower Assembly Instructions

Blower

•  Join the two blower  

tubes A & B together.  

Refer to page 5. 

•  Fit to machine (Fig. 1).  

•  Rotate the tube  

clockwise into locking  

position (Fig. 1). 

•  Fit securing screw provided. 

Vacuum Attachments

•  Unscrew locking wing-

nut and store until 

needed to close safety 

cover (Fig. 2). 

•  Join the vacuum tubes 

#1 & #2 together. 

Refer to page 5. Open 

the safety cover and 

attach the tubes to 

the machine (Fig. 

3). Rotate the tube 

clockwise into locking 

position. 

Whenever possible use 2-cycle oil or equivalent 

oil mixed at a 25:1 ratio. Be aware that generic 

oils and some outboard mixing oils may be 

intended for use in high-performance air cooled 

2-cycle engines, and should never be used in 

your engine.

       WARNING

Danger of fire:

 Never transfer or store fuels in 

the presence of combustible materials. Before 

starting the engine, always move the machine to 

a clear area at least 10-feet (3-metres) away form 

fuels and other combustible materials.

       IMPORTANT

Mix only enough fuel for your immediate needs. If 

fuel must be stored longer than 30-days, it should 

first be treated with a stabilizer or equivalent 

product.

Lock

Lock

Fig. 1

Fig. 2

Fig. 4

Fig. 5

Fig. 6