Bushranger BRV2601, Operator'S Manual

14 

MAINTENANCE & CARE

Storage

If you fail to follow these instructions correctly before storing the machine, deposits may form 

on the interior of the carburettor & may result in the engine being more difficult to start or the 

machine suffering permanent damage.

Storage Preparation
1.  

 Carry out all the maintenance work require prior to storing. 

2. 

  Drain the fuel out of the tank. 

3. 

  When the fuel has been drained, start the engine.

4. 

  Allow the engine to run at idling speed until it stops. This will clean the remainder of the fuel out of the carburettor.

5. 

  Leave the machine to cool (approx. 5 minutes).

6. 

  Clean the exterior housing of the machine.

7. 

  Store the machine in a cold, dry place where it is out of the reach of ignition sources & inflammable substances.

8.   

Always store engine upright. Do not store upside down or on the engines sides.

Fertilizers and other chemical garden products often contain substances that accelerate the rate of corrosion of metals. Do 
not store the machine on or near fertilizers or other chemicals.

Before Restarting

Recheck engine oil is sufficient.

Transport

To transport the machine, first empty the petrol tank. Pump the primer to completely remove fuel from the carburettor 
& empty excess from the tank. Clean coarse dirt off the machine with a brush. Transport Trimmer with engine in upright 
position. Do not transport with engine upside down or on its side.