Installing the 12V Pump
1.
Install the pump in a suitable high and dry position to avoid any contact with
water, as the pump is not waterproof.
2.
It is recommended to secure the pump to a mounting plate or bracket (not
provided).
3.
Checking the direction of flow indicator arrows on the pump.
4)
Connect the pump to a suitable 12 Volt power source (When not using the
Power Cable provided) Installation Tips for fixed mounting:
5.
Operate the pump, inspecting every joint and pipe run for leaks.
a.
Using a hose clamp (supplied), connect a 1.5m length of fresh water hose
to the pump inlet. The other end of the inlet hose is located at a potable water
source.
a.
It is recommended to seek a qualified auto electrician when fixed mounting
of the water pump. It is important to use the correct gauge wire for the distance
from 12V power source and the current draw from the pump. Improper
installation may cause the pump to not function correctly and/or fail.
b.
Be careful to properly route and secure all wiring.
c.
Fuse appropriately.
d.
Toggle switch with adequate amp rating is required to allow for
ON/OFF operation.
b.
Using a hose clamp (supplied), connect the 1.5m length of fresh water hose
with crimped swivel fitting from the pump outlet to the Gas Hot Water Shower.
Important:
The pump must be NOT be installed with the motor
facing downwards.
WARNING:
Do not use a 240-volt pump or other electrical appliances
where they could be affected by water.
Keep pump inlet hose (suction) and pump outlet hose (pressure) as short
as practical as not to exceed suction and pressure head. Excessive
suction or pressure head may cause damage to the pump and will void
warranty.
| Gas Hot Water Shower
Page 11
Summary of Contents for CSG010
Page 1: ...CSG010 ...
