Care and Maintenance
Your LPG Portable Water Heater has a metal casing and a stainless steel face
plate and so, should be cleaned after each use. This will not only maintain the
appearance of your Gas Hot Water Shower, it will also add to its longevity.
Clean your LPG Portable Water Heater by following these steps:
More frequent cleaning may be necessary for coastal and tropical climates or in
salty or corrosive environments.
Always ensure no debris is present in the flue or unit as this may cause a fire
when use.
NOTE:
Failure to clean your LPG Portable Water Heater adequately or failure to
follow these cleaning instructions will void your warranty.
The use of ABRASIVE materials and/or ALKALINE based cleaners will damage the
LPG Portable Water Heater. Their use is strictly prohibited and will void
your warranty.
If you are unsure of how to adequately clean and maintain your LPG Portable
Water Heater, please contact your place of purchase for further information.
If using a water source other than drinking quality water, ensure that the
water inlet filter into the appliance is cleaned after each use.
Storage, Frost / Freezing temperatures: If the appliance is to be stored for any
length of time or subjected to temperatures below freezing, it is necessary to
drain any water trapped in the appliance.
1.
Disconnect the inlet water hose.
2.
Allow the hot water hose and shower rose to hang down.
3.
Loosen the screw in the water drain valve located at the bottom of the
appliance, (near to the water inlet fitting) allowing the appliance to drain.
Gently re-tighten the water drain screw.
1.
Wipe down using a pH neutral soap solution, diluted in clean water.
2.
Only use non-abrasive fibre brushes or sponges while cleaning.
| Gas Hot Water Shower
Page 17
Summary of Contents for CSG010
Page 1: ...CSG010 ...
