LOG SPLITTER
15
Engine On/Off Switch
Recoil Starter Handle
Choke Control
Fuel Shut-Off Valve
Throttle Control
LOG SPINNER FOOT PLATE
The foot plate holds the log in place while
the wedge splits the log.
The foot plate allows the operator to
easily spin a log in prep for splitting and
allows the log to rotate when splitting
instead of causing unnecessary stress on
the beam.
It is easy to replace when the grip teeth
a re d a m a g ed . N o rep a ir wel d in g is
required.
2-POSITION LOG CRADLE
The log cradles are designed to catch the log
after it is split.
2-position function – The
first
positon is
to center logs on the beam. The second
position provides a
fl
at surface and
worktable on which to put logs.
SPLIT CONTROL HANDLE
The control handle is used to move
the wedge up and down to split logs.
The control handle has three positions:
Forward, Neutral, and Reverse. See the
“operation” section for instruction.
MANUAL TUBE
Keep manuals safely in the tube.
BEAM LOCK BRACKET
The beam lock bracket is used to secure
the beam in the horizontal position.
LIFTING HANDLE
The lifting handle is included for easy
transition from horizontal to vertical.
2” BALL HITCH COUPLER
The coupler hitch is at the end of the
tow bar and attaches to a tow ball for
transportation purposes.
4-WAY WEDGE(OPTIONAL)
The 4-way wedge is used to split the log
into four pieces at one time.
LOG STRIPPER
The log stripper is designed to remove
any partially split wood from the wedge.
This may occur while splitting large
diameter wood or freshly cut wood.
BEAM ASSEMBLY
T h e U - b e a m s t r u c t u r a l d e s i g n i s
signi
fi
cantly stronger than a typical I-beam
design.
LOG TABLE (OPTIONAL)
A log table/platform can be mounted on
the log cradle directly.
ENGINE ON/OFF SWITCH
The engine switch has two positions.
OFF -
engine will not start or run.
ON - engine
will start and run.
