Bushranger MC-E-2, Owner'S And Operator'S Manual

＿

 8 

＿

Detaching

1  First, loosen the clamping knob before 

detaching the shaft assembly to the shaft 

coupler.

2  Pull out the shaft assembly from the shaft 

coupler while holding the positioning lever 

down.

3  Note: Do not over loosen the clamping knob 

or it  may fall out.

Idle Speed Adjustment

This Multi-cutter is equipped with non-adjustable fuel mixture carburetor. The idle speed is the only adjust-

ment for the operator.

Please see your Multi-Cutter Power Unit Owner’s/Operator’s Manual.

The cutting attachment may be rotating during idle speed adjustment. Wear the recommended 

personal protective equipment and observe all safety instructions. Keep hands and body away 

from the cutting attachment.
If idle speed adjustment is necessary, and after adjustment the cutting attachment rotates or the 

engine stalls, stop using the Multi-cutter immediately!

Contact your local authorized BUSHRANGER Dealer for assistance and servicing.

 WARNING

POTENTIAL HAZARD

・ 

Engine must be running to make carburetor adjustments.

・ 

When engine is running, attached tool and other parts are moving.

WHAT CAN HAPPEN

・ 

Contact with moving attached tool or other moving parts could cause serious personal injury or 

death.

HOW TO AVOID THE HAZARD

・ 

Keep hands, feet and clothing away from attached tool and other moving parts.

・ 

Keep all bystanders and pets away from unit while making carburetor adjustments.

2  Insert the shaft assembly to the shaft coupler 

with the positioning hole faced up as shown. 

Connect the both drive shafts completely in 

the matching position by moving the shaft 

assembly to forward and backward and left 

turn and right turn. When the shaft assembly 

is positioned correctly, spring tensioned posi-

tioning lever will be returned to the initial 

position.

3  Tighten the clamping knob firmly.

Positioning 

Lever

Positioning lever 

is lowered state

Positioning lever 

is raised state

Incorrect Assembled

Correct Assembled

Clamping 

Knob

Shaft Assembly

Positioning 

Lever

Removal

Push down

Loosen