Bushranger MC-E, Owner'S/Operator'S Manual

＿

 22 

＿

Guard

Knob

Wheel

Increase the 

Depth of Cut

Decrease the 

Depth of Cut

Setting Depth of Cut

IMPORTANT:  Set the depth of cut before you start the engine.

1. Loosen the knob holding the guard to the plate.
2. Rotate the guard as necessary to set the depth of cut. 
Note that:

・ 

Rotating the guard to raise the wheel increases the depth of cut.

・ 

Rotating the guard to lower the wheel decreases the depth of cut.

3. Make sure the guard is positioned to protect the operator from 

thrown debris, then tighten the knob.

Operating Position

Before using the Multi-Cutter with Hedge Trimmer Attachment, check the following:

1. The unit should be on operator’s right side.

2.  The operator’s right hand should be holding the shaft grip, with his or her fingers on the throttle trigger.

The right arm should be slightly bent.

3.  The left hand should be holding the loop handle with the fingers and thumb fully enclosed around the 

grip. Reposition the loop handle up or down the shaft assembly if necessary for a comfortable 

position.

4. The Hedge Trimmer weight should be evenly distributed between the arms.

MC-HT/ MC-HTS (Hedge Trimmer Attachment)

5.  Make sure the cutting blades are moving (at least half throttle ) before actual cutting begins. The Hedge 

Trimmer performs best at full throttle.

6. Always release the throttle trigger and allow the engine to return to speed when not cutting.
7. Stop the engine when moving between work sites.

・ 

If the cutting blades becomes jammed, stop the engine immediately.

・ 

Make certain all moving parts have stopped and disconnect the spark plug before inspecting the equip-

ment for damage.

・ 

Never use a unit that has chipped, cracked or broken blades.

IMPORTANT:  The thickness of branches which may be cut using this trimmer is limited to up to 

approximately 4,5mm. Never try to cut branches thicker than this, as doing so may 

result in damage to the trimmer.

8. When transporting the Hedge Trimmer always fit the blade sheath.

 CAUTION

・ 

Read the Safety instructions beginning on page 2 concerning proper use of the Multi-Cutter.

 CAUTION

・ 

Do not touch the sharpened edges of the cutting blades. The cutting blades are extremely sharp 

and dangerous at all times. Always wear gloves and protective clothing.