Bushranger REVO 10, Owner'S Manual

Gearbox Rotation

Important note:

Important note:

The gearbox end of the winch can be rotated in 22.5° increments to allow for the 

clutch handle to be orientated to best suit the installation requirements.

1). Loosen and partially remove the 8 x bolts (see important note and red arrows 

below) that secure the two gearbox sections to the winch. DO NOT remove the 

gearbox sections from the winch.

2). Rotate the two gearbox sections and bolts simultaneously (all moving parts 

highlighted in grey) to achieve the target angle as highlighted below. Ensure the 

gearbox seal reseats in the correct position.

3). Reinstall and tighten all bolts to 6Nm with torque wrench.

DO NOT USE Power Tool such as impact driver. This may lead to stripping of bolt 

threads and head of socket head bolt. 

DO NOT USE Power Tool such as impact driver. This may lead to stripping of bolt 

threads and head of socket head bolt. 

Motor Rotation

The motor can be rotated to 3 positions in 90° increments to allow for repositioning 

of the poles to best suit the installation requirements. These positions are @ 0°, 90° 

and 270°.

Loosen and remove the 6 x bolts that secure the motor cover to the drum support. 

Remove the motor cover from the winch.

Loosen and partially remove the 2 x bolts that secure the motor to the 

drum support.

Rotate the motor to achieve the desired position, ensuring the motor seal reseats 

into the correct position. Reinstall motor bolts and tighten to 10Nm torque.

Reinstall the motor cover and tighten the 6 x bolts to 1.5Nm with torque wrench.

1.

2. 

3. 

4. 

ISOMETRIC VIEW

N.T.S.

FLAT PATTERN

.

SCALE 

ISOMETRIC VIEW

N.T.S.

FLAT PATTERN

.

SCALE 

Battery Recommendations

A fully charged battery and good connections are essential for the proper 

operation of your winch. 

The minimum requirement for a 12 Volt DC battery is 650 

cold cranking amps.

| REVO VEHICLE RECOVERY WINCH

|REVO VEHICLE RECOVERY WINCH

Page 7

Page 8