Chapter 4
User
Interface
Page 4-14
4.5.2 Product Count, Production Rate, and Belt Speed Display
The Labeler is capable of displaying the job product count (number of products with
labels applied), production rate (in Pieces Per Hour or PPH), or line/transport speed (in
Feet per Minute or FPM). During normal operation (Online mode), the user can cycle
through these displays by pressing the Up or Down arrow keys on the keypad.
4.5.3 Error
Conditions
The Labeler is designed to automatically go offline when an error condition is triggered.
This will automatically stop the labeling process and display an error message. As a
result, the user will need to remedy the problem that caused the error condition. The main
error conditions are listed in
Table 4-2:
Error conditions reported by the Labeler head controller
Error Condition
Cause
Remedy
ONLINE
All systems are operating
normally and no errors are
detected
None. Normal operation.
PRODUCT JAM
Product jammed or the upper
transport was opened during
operation.
Remove jammed product from jam switch.
TAKEUP ERROR
The take-up spool rotates
freely.
Empty label backing paper from take-up
roll and rethread the label backing paper
onto the roll.
COVER OPEN
The Labeler head front safety
cover is opened during
operation.
Close the Labeler head cover.
MATERIAL SIZE
ERROR
There is a misfeed or product
skew.
Check if the product is fed correctly.
Buskro Ltd.
BK731 Labeler
Summary of Contents for BK731
