Increase the DMA transfer rate between the adapter and system mem-
ory.
However, be
when
a higher rate. See
the DMA transfer
rate description in Section 3 before proceeding.
Questions Answers
Q. Why does the “NO ROM BASIC” message appear when booting up?
A. The DOS partition is not activated, run the MS DOS FDISK utility and
set the partition active. Refer to your MS DOS reference manual for
specific instructions on activating a DOS partition using the FDISK
command.
Q. Why is the message “Missing Operating System” displayed during
boot, but the hard drive is still seen by the controller?
A. Check for the active partition. High level format the partition with the
“format
option. Note, this will erase any data currently on your
hard drive. If the drive was previously used on another controller, you
may need to perform a low-level format and then prepare the drive
with DOS Fdisk and Format utilities. If the mapping mode has been
changed since the last hard disk partitioning, perform another Fdisk
and Format.
Q. My system displays a “Hard Disk Failure” message during boot up,
what can I do to correct it?
A. Check all cables and drive jumpers. Make sure the drive type for the C:
drive is “Type or “Not Installed” in System CMOS set up,
Q.
When my system boots up, the
banner shows 6 drives, but
I only have
1
drive. What is wrong?
A. Check that the drive is not the same SCSI ID as the SCSI controller,
which defaults to ID 7. Make sure your drive is set to a SCSI ID other
than 7.
5-2
n
Performance lips
Questions & Answers
n
6-1
Summary of Contents for BT-956C
Page 1: ...m w h 0 0 0 m z n ...
