INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 37 of 111
GB
AIKIDO.34LIGHT-AIKIDO.34LIGHTFI
7101-M001-0_B
WHILE THIS OPERATION IS BE-
ING CARRIED OUT PAY ATTEN-
TION NOT TO DEFORM THE
TYRE SIDE. GREASE THE BEAD
BEFORE THE ROLL RE-ENTERS.
WHILE THIS OPERATION IS BE-
ING CARRIED OUT PAY ATTEN-
TION NOT TO DEFORM THE
TYRE SIDE. GREASE THE BEAD
BEFORE THE ROLL RE-ENTERS.
5. Only now rotate the wheel in clockwise sense press-
ing the pedal (
Fig. 15 Pos. A
) and at the same time
activate the pushbutton (
Fig. 14 Pos. D
) ( ), keep-
ing it pressed until bead breaking has been completed.
Fig. 29
1
Fig. 30
AUTOMATIC (AUTO)
1. After the wheel has been locked, move upper bead
breaker roll (
Fig. 27 Pos. 2
) near to the rim edge,
pushing the push button (
Fig. 14 Pos. C
)( ).
2. Determine the tools diameter (rolls and support)
using the push button
L
and the lever
I
.
Fig. 26
3. Keep on the approaching movement, activating the
wheel rotation in clockwise sense. The contact be-
tween feeler pin and rim edge will activate automati-
cally the progress of the roll (
Fig. 28 Pos. 1
), which
will be inserted between the rim (
Fig. 28 Pos. 2
) and
the tyre (
Fig. 28 Pos. 3
). The same automatism can
be applyed to the lower roll as well.
4. Draw the lower roll (
Fig. 29 Pos. 1
) near the push
button (
Fig. 14 Pos. D
) ( ).
12.3 Bead breaking through vertical rolls
For what concerns bead breaking, there are two differ-
ent options, which can be activated through the selector
(
Fig. 26 Pos. 1
).
1
Fig. 27
2
1
2
3
Fig. 28
6. Once bead breaking has been completed in the lower
part, move lower roll in the rest position activating
the push button (
Fig. 14 Pos. D
) ( ). The roll re-
enters automatically nullifying the approaching move-
ment described at point 3). This automatism can be
applyed on both arms.
7. Rotate the rim until the valve is positioned immedi-
ately at the right side of the roll.
8. Carry out upper edge bead breaking, in the same way,
keeping the push button pushed. (
Fig. 14 Pos. C
)
( ) (see
Fig. 30
).
