Page 48 of 61
INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Press button
, shown on the monitor (
Fig. 41
ref. 2
) or select the field (
Fig. 42 ref. 1
) and subse-
quently press the button
to display the screen
page below:
A
B
Dyn (CAR)
14.5”
312.0 mm
7.5”
AluS (CAR)
14.0”
36.0 mm
13.5”
369.0 mm
KEY
A – Program used in the last carried out spin
B – Acquired measurements for the last carried
out spin
Press any of the available numbers on the buttons at
the bottom of the page to select the corresponding
user. The system stores the data relating to the last
performed spin according to the different operators.
You can recall the desired user each time the pro-
gram displays the specific button (
Fig. 41 ref. 2 and
Fig. 42 ref. 1
). The measurements stored for each
user are lost when the machine is switched off.
User management is valid for any wheel balancer
function.
TO ENABLE OR DISABLE "USER
MANAGEMENT" FUNCTION, SEE
PARAGRAPH 14.1. IF THE FUNC-
TION IS DEACTIVATED, BUTTON
IS DISPLAYED.
14.2 Enabling of electronic Run-out measur-
ing device
From the main page “Home” press the button
to move to the next screen page and the button
to access the user menu. On the monitor, the follow-
ing screen appears where you can enter the password.
The user login password is:
1234
.
After entering the correct password you will see the
following screen:
1
KEY
1 – Options menu push button
1296-M024-01
LIBRAK350 - LIBRAK350PRO
