INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Page 83 of 96
Place the gauge (
Fig. 68 ref. 1
) on the chuck flange
(
Fig. 68 ref. 2
).
Fig. 68
2
1
The following screen will appear on the monitor to
indicate the measured values:
2
1
Fig.
_
69
KEY
1 – Example of value detected by the gauge
2 – Example of value on threaded chuck
- The value next to the symbol "scale" (Fig.
_
69 ref. 1)
must be equal to or ± 1 mm with respect to what is
indicated above the caliper (
Fig._69 ref. 2
).
- Press push button
.
The following screen will appear on the monitor:
- Place the gauge as shown in the following figure:
- Press push button
. Wait a few seconds until
you see the following screen:
- Place the gauge against the chuck in the lower part
of the it but on a smaller diameter than before as
indicated on the image on the monitor.
1301-M001-02
LIBRAK360S - LIBRAK360PS - LIBRAK360WS - LIBRAK360PWS - LIBRAK360WSON - LIBRAK360PWSON - LIBRAK360PWSPRO - LIBRAK360PWS-MC - LIBRAK360PWS-OPEL
