INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 8 of 66
SOME OF THE PICTURES PRE-
SENT IN THIS MANUAL HAVE
BEEN OBTAINED FROM PICTURES
OF PROTOTYPES, THEREFORE
THE STANDARD PRODUCTION
MACHINES AND ACCESSORIES
CAN BE DIFFERENT IN SOME
COMPONENTS.
1.0 GENERAL INTRODUCTION
This manual is an integral part of the product and
must be retained for the whole operating life of the
machine.
Carefully study the warnings and instructions con-
tained in this manual. It contains important instruc-
tions regarding
FUNCTIONING, SAFE USE and
MAINTENANCE.
KEEP THE MANUAL IN A KNOWN,
EASILY ACCESSIBLE PLACE FOR
ALL ACCESSORY OPERATORS
TO CONSULT IT WHENEVER IN
DOUBT.
THE MANUFACTURER DISCLAIMS
ALL RESPONSIBILITY FOR ANY
DAMAGE OCCURRED WHEN THE
INDICATIONS GIVEN IN THIS
MANUAL ARE NOT RESPECTED:
AS A MATTER OF FACT, THE NON-
COMPLIANCE WITH SUCH INDI-
CATIONS MIGHT LEAD TO EVEN
SERIOUS DANGERS.
1.1 Introduction
Thank you for preferring this electro-hydraulic tyre
changer. We feel sure you will not regret your decision.
This machine has been designed for use in profes-
sional workshops and in particular it stands out for
its reliability and easy, safe and rapid operation: with
just a small degree of maintenance and care, this tyre
changer will give you many years of trouble-free service
and lots of satisfaction.
7505-M001-3_B
NAV11N - NAV11NT
NAV11EI - NAV11TEI
2.0 INTENDED USE
The machines model “NAV11N
,
NAV11NT
, NAV11EI
and
NAV11TEI
”, with relevant versions, are tyre
changers with electro-hydraulic working, to be used
only for the mounting and demounting of any type of
wheel with whole rim (with groove and bead wire),
with maximum dimensions of 1640 mm/64” and
maximum weight of 1500 kg. The machines model
“NAV11N
,
NAV11NT
, NAV11EI
and
NAV11TEI
”
with relevant versions, are NOT to be used for tyres
inflation.
THIS MACHINE MUST BE USED
STRICTLY FOR THE INTENDED
PURPOSE IT WAS DESIGNED FOR
(AS INDICATED IN THIS MANUAL).
ANY OTHER USE WILL BE CON-
SIDERED IMPROPER USE. IN
PARTICULAR BEAD FITTING AND
INFLATING MUST BE CARRIED
OUT IN A SPECIALLY APPROVED
INFLATION CAGE.
THE MANUFACTURER CANNOT
BE HELD RESPONSIBLE FOR ANY
DAMAGE CAUSED BY IMPROPER,
ERRONEOUS, OR UNACCEPTABLE
USE.
AN INTENSIVE USE OF THE EQUIP-
MENT IN INDUSTRIAL ENVIRON-
MENT IS NOT RECOMMENDED.
2.1
Staff training
The machine may be operated only by suitably
trained and authorized personnel.
Given the complexity of the operations necessary to
manage the machine and to carry out the operations
safely and efficiently, the personnel must be trained
in such a way that they learn all the information
necessary to operate the machine as intended by the
manufacturer.
A CAREFUL READING OF THIS
INSTRUCTION MANUAL FOR
USE AND MAINTENANCE AND A
SHORT PERIOD OF TRAINING
WITH SKILLED PERSONNEL CAN
BE AN ENOUGH PREVENTIVE
PREPARATION.
