20
• The products should only be assembled by authorized persons.
• Since products have sharp edges, wearing gloves is recommended.
• If entrance and exit of the products are going to stay open, they should
be covered with a culvert to prevent foreign materials from entering.
• Before connecting electric cables, you must not forget to cut the power
supply.
• When assembling the devices, be sure that all connections are correctly
established and that the assembly elements are strong enough to carry
the weight of the product.
• Even if the product is turned off, be sure that the main power supply is
off while connecting the devices.
• Before assembly, check whether the electrical connection information
on the product (tension, power, frequency, etc.) conform to the area
where the product will be assembled.
• The terminal box cable inlet should be firmly plugged in. The lid should
be closed correctly and should prevent water leakage.
• There shall not be any obstacles in the air flow route.
• For safety reasons, the earthing terminal on the electric terminal should
absolutely be connected to the building earthing line.
• Be sure that the motor thermic relay and overload relay are connected
correctly.
• Cable connection of the product should be like the one in the electrical
connection diagram.
