16
CONNECTION
• Products should be installed only by authorized persons.
• Installation of the product to be specified in the Project location to the
wall or floor must be securely mounted. If mounted on the wall,it should
mounted with bracket or with clamps.
• Fan blades to be above 2,3 m from the floormust be installed.
• Fan can not be installed out side the window or wall.
• Open the gas pipeoro the fuel-burning devices inside of the room to
avoid there flux of gas is necessary to take pre-measures.
It is recommended that gloves be worn in the assembly of products.
• The product must be connected to input and output channels.
• Electrical cords definitely turn off the power before connecting.
• When mounting brackets and mounts all the connections are made cor-
rectly to carry the weight of the product, make sure you have the strength.
• Even if the product off the main power supply is switched off when
connecting equipments make sure that.
• Before mounting the electrical connection indicated on the product
information (voltage, power, frequency, etc..) In the place of assembly
are in keeping with that note.
• There is noob struction on the air flow way.
• Interms of safety ground terminal located on the terminal must be
connected to earth certainly building.
• Motor thermal and overload relay make sure they are connected properly.
• If the thermal opens circuit during in any problems (while the product is not
working) it must be reset from the system network and activated again.
• Product wiring, electrical connections must be as in the diagram.
• Contact separation in all poles along with a switch that must be
connected to fixed wiring installations in accordance with the rules.
BPR_klavuz2021.qxp_Layout 1 15.03.2021 17:38 Page 19
