Version 202001 Updated 08/2020
２８
chips well
hammers
hammers for damage.
Anvil gap incorrect.
The gap should be no smaller than 0.5mm
and not bigger than 1mm
Loose, worn, or damaged V-belt
Replace or tighten V-belt
Chips do not come
out
of
the
discharge chute or
come out slowly
Discharge chute or hopper is
clogged
Turn OFF the motor, disconnect the spark
plug, then clean out the machine
Insufficient motor RPM
Move the throttle to FAST
Blocked rotor
Overloading of the chipper
Stop the machine, and remove the chute
and the cap of bearing, turn the shaft of
roller with a spanner to clear the blocked
material
10. TRANSPORTATION
Never lift or transport the chipper/shredder while the engine is running. It is
necessary to always turn off the engine when transporting the machine
between different working areas.
Once the machine is turned off, wait for 5 minutes to allow it to cool before
transporting it. The machine’s exhaust pipe will remain hot after turning off
the engine.
If you have to raise the machine, check the weight of the machine in the
technical characteristics before lifting it to ensure that it is a weight that you
can withstand.
Transportation of the machine should be carried out by two persons to
avoid possible injuries.
11. STORAGE
Once the machine is switched off, wait for 5 minutes for it to cool down
before storing the machine. The machine’s exhaust pipe will remain hot
after turning the engine off. Never store the machine in places near
flammable materials (dried grass or wood), gas or fuels.
Be sure to store the machine in a place not accessible to children or that it
may create possible danger for anyone and that is stored in a dry, clean
place with a temperature between 0
℃
to 45
℃
.
