Version 202001 Updated 08/2020
６
order to improve the flow of clean air from the area in order to improve
ventilation. Do not return to the area unless you have properly ventilated
the area and are certain that ventilation is sufficient so this does not happen
again.
Petrol and oil are extremely flammable and explosive under
certain conditions. Do not smoke in the area. Keep flames,
sparks or heat sources away from the machine.
Do not smoke while transporting fuel, when you fill out the deposit or when
you are working with the machine.
Do not refuel in locations where there is the presence of open flames,
sparks or heat sources. Fill the tank always in well-ventilated areas and with
the motor stopped. Do not overflow fuel when filling the fuel tank. Make
sure to correctly and tightly close the cap on the fuel after refilling. In the
event of a fuel leakage, be sure to clean these leaks completely before
starting, move the machine away from the spillage area and avoid any
source of ignition until all vapours are gone. Add fuel before starting the
machine.
Never remove the cap of the fuel tank while the engine is running or when
the machine is hot. Make sure the cap of the fuel is tightly and correctly
closed while you are using the machine.
Do not use fuel that has been stored for longer than 2 months.
2.5 CARE AND USE OF THIS MACHINE
The chipper is only designed to shred pieces of woods. It is prohibited
to shred any other materials ( for example metal, stones, plastics and
any other materials). If you want to shred roots, remove the sand, mud or
other residues before shredding. Any other use of the shredder not
described here, annuls the warranty responsibility of the manufacturer.
Check that all the safety devices are installed and in good condition.
Remember that the machine operator is responsible for the dangers and
accidents caused to other people or things. The manufacturer will not be in
any way liable for damages caused by improper or incorrect use of this
machine.
