15” Panel PC User’s Manual
P46
The choice: Enabled, Disabled.
15” Panel PC User’s Manual
P11
Function
JP1
Normal (Default)
1-2
Clear CMOS
2-3
OnChip IDE/PCI Device:
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Select “Enabled” to activate each channel separately.
y
Figure:
JBA T1
1
The choice: Press Enter.
OnChip Primary/Secondary PCI IDE:
LCD Panel Voltage Select: JP1
Function
JP1
5V
1-2
3.3V
2-3
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Select “Enabled” to activate each channel separately.
The choice: Enabled, Disabled.
y
Figure:
1
JP1
IDE Primary/Secondary Master/Slave PIO:
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode
(0-4) for each of the four IDE devices that the onboard IDE interface supports.
Modes 0 through 4 provide successively increased performance. In Auto
mode, the system automatically determines the best mode for each device.
COM2 RS232/422/485 Setting Select: JP2
J6
J7
J8
Function
1-2 2-3
1-2 2-3
1-2 3-4
RS-232
On
Off
Off
On
Off
Off
RS-422/485
Off
On
On
Off
On
On
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3 and Mode 4.
y
Figure:
1
J6
J7
IDE Primary/Secondary Master/Slave UDMA:
Ultra DMA/33 implementation is possible only if your IDE hard drive supports
it and the operating environment includes a DMA driver (Windows 95 OSR2
or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, select “Auto” to enable BIOS support.
1
J8
J11 COM4 Setting Select: J11
This jumper setting is secect pin9 function.
The choice: Auto, Disabled.
Function
JP11
+5V
1-2
RI (Default)
3-4
+12V
5-6
USB Controller:
Select “Enabled” if your system contains a Universal Serial Bus (USB)
controller and you have USB peripherals.
y
Figure:
J1 1
1
The choice: Enabled, Disabled.
USB Keyboard Support:
Select “Enabled” if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.