15” Panel PC User’s Manual
P17
y
Figure:
Typematic Rate Setting:
Keystrokes repeat at a rate determined by the keyboard controller. When
enabled, the typematic rate and typematic delay can be selected.
1
JLV D S 1
The choice: Enabled, Disabled.
Typematic Rate (Chars/Sec):
Sets the number of times a second to repeat a keystroke when you hold the
key down.
The choice: 6, 8, 10, 12, 15, 20, 24 and 30.
VGA Connector Pinout: JVGA
Pin #
Assignment
Pin #
Assignment
1
Red
2
Serial Date
3
Green
4
Serial CLK
5
Blue
6
GND
7
V_SYNC
8
GND
9
H_SYNC
10
GND
Typematic Delay (Msec):
Sets the delay time after the key is held down before it begins to repeat the
keystroke.
The choice: 250, 500, 750 and 1000.
y
Figure:
1
JVG A 1
Security Option:
Select whether the password is required every time the system boots or only
when you enter setup.
JCOM1 Connector (2.00mm Pin-Header) : JCOM1
System---The system will not boot and access to Setup will be denied if
Pin #
Assignment
Pin #
Assignment
1
DCD (Data Carrier Detect)
2
RXD (Receive Data)
3
TXD (Transmit Data)
4
-DTR (Data Terminal
Ready)
5
Ground
6
-DSR (Data Set Ready)
7
-RTS (Request to Send)
8
-CTS (Clear to Send)
9
RI (Ring Indicator)
10
No Connect
the correct password is not entered at the prompt.
Setup---The system will boot, but access to Setup will be denied if the
correct password is not entered at the prompt.
Note: To disable security, select PASSWORD SETTING at Main Menu and
then you will be asked to enter password. Do not type anything and
just press <Enter>, it will disable security. Once the security is
disabled, the system will boot and you can enter Setup freely.
y
Figure:
JC O M 1
1
P40
15” Panel PC User’s Manual