26
Manual
SOFTENER FER27-A6X
code P0011148 - Rev 1 - 15/03/2017
En
g
li
s
h
The hardness is increased or reduced by turning the knob
clockwise or counterclockwise.
The adjusted hardness depends on the use of the soft wa-
ter. The legislation sets the value of the hardness of water
dedicated for human consumption.
NOTE:
it is under the user’s responsibility to defi ne the residual
hardness compatible with the equipment installed downstream
of the softener.
OPERATION
Salt refi ll
The device uses regenerating salt, dedicated to softening. The salt tank bottom shall always be co-
vered by solid salt over its whole surface. Please refer to the Scope of Delivey sheet in order to know
the salt storage capacity of your softener, and to the chapter «TECHNICAL FEATURES» to know its
salt consumption per regeneration.
Automatic displayed messages
The displays shows:
Œ
an upper information line
•
a lower information line
Ž
a bargraph with 10 segments, showing the
remaining autonomy of the softener before the
next regeneration, by steps of 10%. The graph
in this example shows 80% remaining autonomy
For each operation step of the device, the displayed messages are as follows:
SERV
12:30
Alternate with
968
12:30
The device is in service: it delivers softened water.
Its treatment autonomy before regeneration is here 968 liters.
REMPL
375
Water is being poured into the salt tank (see chapter ADVANCED
SETTING), it will end in 375 seconds.
SAUM
180
The brine is under preparation in the salt tank for the next regene-
ration; this step will end here in 180 minutes.
ASPI
39:45
The softener is going through its fi rst regeneration step see chapter
ADVANCED SETTING), which will end here in 39 minutes and 45
seconds.
RINCE
01:55
The softener is going through its second regeneration step, which
will end here in 01 minute and 55 seconds.
REMPL
06:51
The softener is going through its fi st regeneration step, which will
end here in 06 minutes and 51 seconds.
CHECK
Alternate with
SALT
The softener detects a lack of salt and advises to check the salt
level in the salt tank.
Please note that the countdown time is frozen when the motor is running. This can last for 10 to
40 seconds. The displayed phase is in progress when the countdown is underway.
Œ
•
Ž
