2019/08 - Indice de révision : D - Code : 29650
TRAITEMENT DE L'EAU
51/72
2 metres, subject to the condition that its power cable is directly connected to a 30mA residual current
device (as stipulated in the standard NF C 15-100).
Mount the panel on a flat, solid, vertical wall in the plant room using the 2 mounting brackets. For added
safety, position the panel at a height inaccessible to children.
!
IMPORTANT
•
To allow the panel to cool properly, do not obstruct the flow of air behind the panel.
•
Do not install the panel is a closet or any other place where inadequate ventilation could cause the
device to overheat and catch fire.
IMPORTANT ! :
l’extrémité de mesure des sondes doit toujours rester immergée, voir
Paragraphe IV.1 pour leur montage hydraulique.
IV.4) Montage du co
ff
ret d’(alimenta
ti
on et de contrôle
Rappels :
Le co
ff
ret d’alimenta
ti
on et de contrôle est classi
fi
é IP 56 (indice selon EN 60529). Il ne craint
donc pas les éclaboussures, mais il convient de le posi
ti
onner à une distance minimum de
3,5 mètres du plan d’eau.
En cas d’impossibilité, il peut être posi
ti
onné à moins de 3,5 mètres, mais dans tous les cas à
plus de 2 mètres du plan d’eau, sous réserve que son câble d’alimenta
ti
on soit directement
relié à un disposi
ti
f di
ff
éren
ti
el résiduel déclenchant à 30 mA (exigences norme NF C 15-
100).
Fixer le co
ff
ret à une paroi ver
ti
cale plane et solide du local technique par le biais de ses
deux pa
tt
es de
fi
xa
ti
on. Pour plus de sécurité, posi
ti
onner le co
ff
ret sur la paroi à une
hauteur su
ffi
sante pour qu’il soit inaccessible aux enfants.
IMPORTANT ! :
-
Ne pas obstruer le passage d’air au dos du co
ff
ret pour son refroidissement.
-
Ne pas enfermer le co
ff
ret dans un placard ou autre habillage où une ven
til
a
ti
on
insu
ffi
sante risquerait d’entrainer une surchau
ff
e du co
ff
ret et un risque d’incendie.
Radiator
2 fixing points
Thickness: 95 mm
Cell cable length: 3.60 m
4.7.1 Connection of the various components to the electrical panel
Remove the cover from the compartment containing the terminal connections.
Pass the connection cables through the cable glands located below the connection points.