2019/05 - Indice de révision : H - Code : 26660
FILTRATION
BWT myPOOL
34/40
2.
ELECCIÓN DE LA UBICACIÓN
El grupo de filtración se situará imperativamente en una superficie plana, a una distancia mínima de 3.50
m de la piscina (Normativa C15-100). Se protegerá imperativamente la línea eléctrica suministrando el
grupo de filtración en cabeza de línea mediante un disyuntor diferencial de 30 mA. Se colocará también
cerca de un desagüe para realizar el lavado del filtro.
3.
ENSAMBLAR EL GRUPO Y CARGAR EL FILTRO
Colocar la bomba sobre el zócalo
y sujetarla con dos tornillos, arandelas
y tuercas.
2
Colocar el filtro sobre el zócalo
posicionando el tapón de vaciado en el
recorte correspondiente.
4
Ensamblar el zócalo clipsando las dos
uñas del soporte de bomba (A) en las
muescas del soporte de filtro (B).
1
A
B
Tapón de
vaciado
Recorte
Atornillar el tapón de vaciado.
3
Desatornillar y sacar el anillo
cintura.
5
Sacar el conjunto tapa/válvula. Este se
colocará al revés para el transporte.
6