Section 4
– Assembling Your Guitar
JEM Section 4
- 3 -
2.
Carefully insert the Pick Guard into the Pickup Pocket (Figure 4.1). Ensure that
the wiring bundle fits in the channel between the pickup pockets:
a)
with the Blue & one Black wire (typical) running through the tunnel (Figure 4.4.1-2) between
the Control Pocket and the Jack Pocket, and
b)
with the black ground wire (typical) running through the tunnel (Figure 4.4.1-2) between the
Control Pocket and the Tremolo Pocket in the
back of the Body.
c)
Seat the Pick Guard – gently pulling the wires
to ensure they are through the tunnels.
d)
As done in the Mock up (Section 2.3), carefully
move the Pick Guard so that it is aligned with
the Neck Pocket and the contours of the body.
Using 3/8” screws (item 3 on Material list),
attach the Pick Guard.
4.4.2
Neck Installation
1.
Insert the neck into the neck pocket, aligning the mounting holes in the neck and body;
Figure 4.4.1-2 Body Wiring
Figure 4.4.1-1 JEM Wiring Diagram
