Section 4
– Assembly
SG Section 4- 9 -
7.
Adjust the hole in the first tuner to be perpendicular to the neck.
8.
Run the string upward over the Bridge saddle and through the hole in the tuner till snug on the
neck; gently pull the string backward for a length of about 2 frets (check the video).
9.
Run the string forward (toward the end of the headstock) wrapping the around the tuner and
under the sting; bend over the string (toward the end of the headstock).
10.
Tighten the string down the tuner; when the string is snug against the 1
st
slot in the nut, trim the
excess string.
11.
Repeat steps 2-6 using the next smaller diameter string & the tuner.
4.6
Installing the Strap Pins
Secure each strap pins (2) in the pre-
drilled holes with the supplied screws (2ea, 1”).
Assembly of
your
Guitar is now complete
–
let’s set it
up!!
