You will install the LED at the same time you mount the circuit board.
1. Insert the LED into its slot on the underside or solder side of the circuit board,but DO
NOT SOLDER it yet. Make sure the anode(the long leg) goes in the round solder pad and
the cathode(the short leg)goes in the square solder pad. This is opposite of how a PCB
mounted LED should be installed. This is unique only to the Tonebender kit.
2. Once you have the LED in place, bend the leads a little bit so that it will not fall out when
you turn the PCB over.
3. Install the nylon circuit board standoffs into the mounting holes.
4. Remove the paper backings on the standoff to expose the self-adhesive tape.
5. Insert the LED bulb into the LED hole in the enclosure.
6. Secure the Standoffs to the back of the potentiometers.
7. Your LED should still be free to move up and down slightly. You probably do not want
your LED sticking all the way out of the hole. So pull up on the LED legs till you have it
properly positioned and then solder.
8. Clip off the excess LED leg wire.
