18
Cut 1 x 1.5” piece of wire. Strip 1/4” off each end. This will be used to connect the
ring of the IN jack to the ring eyelet on the PCB.
Step 3: Solder the wires for the footswitch.
Step 4: Remove the PCB assembly from the enclosure. Solder the open ends of the
wires that you just soldered to the footswitch to their respective eyelets on the PCB.
Load the wires in from the top and solder on the bottom side.
Step 5: Reinstall the PCB assembly to the enclosure. Install the footswitch to the
enclosure. It will have a white nylon washer and a silver metal washer. You can decide
which washer you want to be visible on the outside of the enclosure.
Step 6. Solder the jacks to the PCB.
Summary of Contents for Octave Fuzz
Page 19: ...20 ...