The Neck
On a maple fingerboard you can apply a clear finish to the entire neck and fingerboard. Apply several
coats and remove buildup on the frets between coats. An easy way to remove the finish buildup on the
frets is to take a nail and file a half round slot in the head about the same size as the frets. You can then
use this to easily scrape any finish build up.
If the neck has a Rosewood or Ebony fingerboard be sure to tape off the fingerboard before applying the
finish.
Electronics
After the finish is complete you can begin installing the pickups and pots. All the electronics can be
mounted in the pickguard and wired. The body is routed to allow the wires to run under the pickguard.
The pots and switch come pre-wired in a harness. Mount them in the pickguard along with the jack.
Solder the pickups to the switch and pots using the below wiring diagram.
The following diagram shows the connection of the pickups to the pots and switch.
Pickup wiring diagram
Summary of Contents for V Guitar Kit
Page 1: ...V Guitar Kit Assembly Instructions...
Page 10: ......
