ELECTRONIC RED DOT FINDER
MOUNTING & ALIGNMENT
TO MOUNT:
1) REMOVE ELECTRONIC RED DOT FINDER FROM BOX.
2) LOOSEN THUMB SCREWS ON SIDE OF FINDER AND SLIDE FINDER ONTO
DOVETAIL MOUNT LOCATED AT TOP OF MAIN TELESCOPE TUBE.
3) TIGHTEN THUMB SCREWS.
TO CHECK ALIGNMENT WITH MAIN TELESCOPE:(IMPORTANT!)
1) THE ELECTRONIC RED DOT FINDER IS NOT PRE-SET AT FACTORY. THE
FOLLOWING WILL ALLOW YOU TO ADJUST THE ALIGNMENT.
2) DURING THE DAY LIGHT HOURS, AIM THE MAIN TELESCOPE AT AN OBJECT AT
LEAST ¼ MILE OR MORE IN THE DISTANCE AND BRING IT INTO FOCUS.(VERY
IMPORTANT)
3) ONCE YOU HAVE CENTERED THE REFERENCE ITEM IN THE MAIN TUBE, TIGHTEN
ALL KNOBS AND ADJUSTMENTS TO PREVENT ANY MOVEMENT.
4) REMOVE CIRCULAR BATTERY SAVER LOCATED BENEATH FRONT OF FINDER
(BE SURE TO SAVE AND REPLACE THE BATTERY SAVER WHEN NOT IN USE.)
5) TURN FINDER ON BY SLIDING ON/OFF SWITCH FORWARD. ON/OFF SWITCH IS
LOCATED ON THE RIGHT SIDE OF THE FINDER.
6) LOOK THROUGH THE FINDER AND LOCATE THE RED DOT.
7) IF THE OBJECT IN THE ELECTRONIC RED DOT FINDER IS
NOT THE OBJECT YOU SEE THROUGH TH E MAIN
TELESCOPE TUBE, ADJUSTMENT IS REQUIRED.
8) TO MOVE THE RED DOT UP AND DOWN, SIMPLY TURN THE
ELEVATION SCREW LOCATED ON THE REAR BOTTOM OF THE FINDER TO HEIGHT
REQUIRED.
9) TO MOVE THE RED DOT LEFT AND RIGHT, SIMPLY TURN THE WINDAGE SCREW
LOCATED AT THE FRONT LEFT SIDE OF THE FINDER TO THE PROPER POSITION.
10) THESE ADJUSTMENTS WILL ALLOW YOU TO POSITION THE RED DOT ON THE
SAME OBJECT CENTERED IN THE MAIN TELESCOPE.
11
