Protective Gear
Personal Protective Equipment (PPE) must comply with the
American National Standards Institute’s ANSI Z87.1-1989
standard if purchased after July 5, 1994, or ANSI Z87.1-1968
or with the standard of the country in use.
•
Eye and face PPE shall be distinctly marked to facilitate
identification of the manufacturer. (1910.133[a][4]).
•
The following minimum requirements must be met by all
protective devices. Protectors shall:
-
Provide adequate protection against the particular
hazards for which they are designed
-
Be of safe design and construction for the work to be
performed
-
Be reasonably comfortable when worn under the
designated conditions
-
Fit snugly and not unduly interfere with the movements
of the wearer
-
Be durable
-
Be capable of being disinfected
-
Be easily cleanable
-
Be distinctly marked to facilitate identification only of
the manufacturer
THE USE OF EYE WEAR PROTECTION IS RECOMMENDED AS
MINIMUM PPE WHEN USING THIS DEVICE.
ALWAYS USE APPROPRIATE PPE, LISTED ON THE
BYOPLANET
®
-APPROVED PRODUCT’S SAFETY DATA
SHEET (SDS).
ByoPlanet
®
SDSs CAN BE FOUND AT:
WWW.SERVICETECHTEAM.COM
When using an electrical appliance, it is important to
understand that some circuits are electrically live, even
when the power switch is in the off position. Basic safety
precautions should always be followed to reduce the risk
of burns, fire, electrical shock, injury and/or death.
Power Connection
Our power plug must be used with a three-pronged, ground-
ed outlet, rated for no less than 15A service. Always verify
before product use. This appliance is for use on a nominal
120V/60Hz circuit with a verified ground plug. Check with a
qualified electrician to ensure you have the correct electrical
service and grounding.
Grounding Instructions
This appliance must be grounded. In the event of malfunction
or breakdown, grounding provides a path of least resistance
for an electric current to reduce the risk of electric shock.
This appliance is equipped with a cord having an equip-
ment-grounding conductor and a grounding plug. The plug
must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and
ordinances. Never use an adapter that removes the ground
connection with this device.
DANGER:
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The conductor
with insulation having an outer surface that is green, with or
without yellow stripes, is the equipment-grounding conduc-
tor. If repair or replacement of the cord or plug is necessary,
do not connect the equipment-grounding conductor to a live
terminal. Check with a qualified electrician or serviceman if
the grounding instructions are not completely understood or
if in doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance — if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician. Never use an adapter that removed the ground
connection with this device.
Extension Cord
ByoPlanet
®
provides a 25-foot (7.6m) extension cord with
each ByoPlanet
®
MS-700™ Electrostatic Sprayer and
strongly recommends that you use this approved extension
cord. Make sure your extension cord is in good condition.
Inspect cords periodically and replace if damaged. If an
alternate extension cord is used, be aware that an undersized
extension cord will cause a drop of in-line voltage, which
could result in a loss of power, damage to the product and/or
overheating. Always use a sufficiently rated extension cord.
IMPORTANT:
ByoPlanet
®
recommends using a 12/3 gauge
extension cord, no longer than 100 feet (30.5m). For outside
or wet environment application, use a GFCI (ground fault
circuit interrupter) in-line adapter or outlet to help avoid risk
of electrical shock. The GFCI should be placed as close to the
outlet as possible.
IMPORTANT SAFETY PRECAUTIONS
ENGLISH | 5
BYOPLANET.COM
