BZBGEAR BG-BSHA
PRODUCT MANUAL
Network Connection
To successfully complete this process, you will need several pieces of information. The first
is the IP address of your computer. You will also need to select an unused IP address on
your local network (This is the address you will set the camera to). The third piece is the
default IP address of your camera. Finally, you will need the IP address of your Default
Gateway/Router.
All versions of the BZBGEAR BG-BSHA series cameras have the following default IP
address:
192.168.1.162
The computer must be on the same subnet as the camera to connect successfully,
therefore the computer must be connected to the 192.168.1.x subnet. If your network is
already using this IP address pool, simply enter the camera's IP address to connect. If it is
not,you will need to change the adapter settings in the Local Area Network Properties on
the computer.
• Right-click on the internet connection in the lower right corner of the desktop and
select "Open Network & Internet Settings".
• Select “Change Adapter Options".
Address:
830 National Drive #140, Sacramento, CA 95834, USA
·
Tel:
+1(888)499-9906
·
Email:
support@bzbgear.com
11
