8
How To Repackage the CAT JL7 Power Amplifier:
1.
Put the box on the ground.
2.
Put the large piece of foam inside the bottom.
3.
Put the amplifier in the cardboard cradle. Make sure the protective foam sheet is still in place,
particularly in the front where it protects the shiny front plate.
4.
Line the box with the 4 smaller pieces of foam. The two smallest in the front and back
5.
Gently lift the amplifier up in the cradle and lower it down into the box, between the 4 side
foams.
6.
Insert the two folded up cardboard pieces on the left and right sides of the amp. Make certain
that the foam sheets taped to these pieces are touching the amplifier.
7.
Fold the cardboard handles over the top of the amplifier. Make certain the protective foam
sheet covers the shiny mirrored finish top plate.
8.
Put the other large foam piece on the top
9.
Seal up the top of the box with packing tape.
