C&K Securitech
9
CIRCUIT PROGRAMMING MATRIX REFERENCE GUIDE
LED 1
LED 2
LED 3
LED 4
LED 5
LED 6
TAMPER LED
ALARM
ISOLATE IN
HOME SET
ISOLATE IN
NIGHT SET
WALK THROUGH
ENTRY ROUTE
CHIME
ISOLATE
PERMIT
FULL SET
ENTRY ZONE
NIGHT SET
ENTRY ZONE
WALK THROUGH
ENTRY ROUTE
CHIME
ISOLATE
PERMIT
24 HOUR ZONE
BELLS &
STROBE
WARNING
TONE
FIRE
BELLS &
STROBE
P.A.
VIEW FROM LEFT TO RIGHT. USE KEY 1 TO 6 TO SWITCH LED ON OR OFF.
ZONE TYPES ARE SHOWN IN BOLD TYPE. COLUMNS TO THE RIGHT OF THE
ZONE TYPE SHOW APPLICABLE OPTIONS. MORE THAN ONE PER ZONE TYPE
MAY BE SELECTED. SELECT A PRIMARY OPTION (BOLD TEXT) THEN SELECT
ANY SECONDARY OPTION BY GOING TO THE RIGHT FROM THE ONE YOU
CHOOSE. IN ROW 2, FULL SET ENTRY AND NIGHT SET ENTRY MAY BOTH BE
APPLIED TO THE SAME ZONE. LED NUMBERS AT THE TOP OF THE CHART DO
NOT
REFER TO THE ZONE NUMBER.
ZONE ATTRIBUTES AND MEANINGS
.
ALARM.
A standard alarm zone. This zone will signal alarm if tripped
while the control is in the fully armed condition. In the day condition visual
indication may be programmed. (option 7-4-1)
FULL SET ENTRY ZONE.
This zone type controls the entry and exit to
and from the alarm system. When the control is armed tripping the zone
will start a timed entry period during which time the system should be
disarmed. Failure to do so will result in a full alarm condition. When
arming is requested this is the last zone to pass through before leaving
the system. It can be fully set using a timer or by seeing the last sensor
close or reset. (final contact closure). Alternatively a terminator set button,
outside the protected area can arm the system, if all zones are clear. If a
zone is programmed for both Full set and Night set entry it can be final
contact setting in the former and timed entry/exit in the latter.
NIGHT SET ENTRY ZONE.
This zone type has the same attributes as the
Full set entry zone except that it is associated with one of the night set
conditions. Night Set or Home Set. Even when the system is only partly
armed we still need some method of entering and leaving it. Although a
single zone may be programmed for both types of operation it may also
be 2 different ones.
