iNetVu New Gen Troubleshooting Guide
C-COM Satellite Systems Inc.
Page 51 of 68
Step 1: Testing the Limit Switch.
a.
Verify that the limit switch is connected to the wiring harness.
b.
Place a metal object to the tip of the limit switch so see if the switch activates. This will be
indicated by an LED on the switch or from the Controls screen of the iNetVu Mobile 7000
software.
c.
From the iNetVu Mobile 7000 Controls screen does the Elevation ST come ON?
If YES, it concludes the limit switch is too far from the target and it needs to be brought closer until the
Elevation ST comes on. Loosen the nut and slowly thread the Sensor towards the target until EL ST
comes ON. Tighten the nut.
If NO, proceed to Step 2
Step 2: Testing the Wiring Harness.
a.
Disconnect the Elevation limit switch from the internal wiring harness and place a paper clip or
a looped wire in the connector going to the wiring harness.
b.
From the iNetVu Mobile 7000 Controls screen does the Elevation ST come ON?
If YES, this concludes the Switch has failed
If NO, proceed to Step 3
