To prevent damage to your CC QuickCharger-2 or possible injury to you or others, read these safety precau-
tions and instructions entirely before applying power to the charger. Keep these precautions and instructions
where all who use this charger will read them.
1.
COMMON CARE
m
Check the charger and AC-DC adapter regularly. Do not use the charger if there is any sign of damage.
Only operate in accordance with the in struc tions in this manual.
2.
DISCONNECT THE CHARGER IN CASE OF MALFUNCTION
m
If you smell or notice smoke, disconnect the AC Adapter and let the charger cool and batteries cool before
touching, to avoid burns. Contact C. Crane Company or their representative for inspection and service
before any future operation. Only use the AC-DC Adapter recommended with the unit and replace it if
wires become frayed or exposed. It should be a regulated 12 Volt 1Amp adapter with center tip positive.
Use only the recommended adapter. Otherwise it may damage the charger or cause a fire or electric
shock.
3.
KEEP OUT OF REACH OF CHILDREN
m
Dropping the charger can cause damage or injury. Keep the AC Adapter cord in a position so someone
cannot trip and cause the charger to fall.
4.
KEEP AWAY FROM WATER AND MOISTURE
m
Keep the charger in an indoor, dry location. Liquids and moisture can damage the charger. If a liquid leaks
into the charger do not operate and seek a qualified service shop. To clean the charger, remove the power
and use a damp cloth on the exterior only.
5.
KEEP AWAY FROM EXTREME TEMPERATURES
m
Extreme temperatures can damage the charger. Do not leave or use the charger where it can be subject-
ed to high or very cold temperatures.
6.
DO NOT ATTEMPT TO SERVICE CHARGER
m
Refer all service work to a qualified service shop if the charger does not appear to operate normally,
exhibits a change in performance or has received damage. Never open the charger as this may expose
you to dangerous voltages and this will void all warranties.
BATTERY SAFETY RULES
•
Only recharge AAA, AA, C, D size and 9 Volt Nickel Metal Hydride (NiMH) batteries.
DO NOT ATTEMPT TO RECHARGE ALKALINE BATTERIES OR ANY OTHER TYPE OF BATTERY.
• Do not try to recharge batteries that are rusty, corroded, damaged or leaking.
• Make sure the polarity marked on the rechargeable battery matches the polarity marked in the
CC QuickCharger-2 compartment.
READ BEFORE OPERATING EQUIPMENT
SAVE THESE INSTRUCTIONS
c
m
Page 2
CC QuickCharger-2
LCD Display Identification
CHARGE
DISCHARGE
FULL
BAD
Battery
Status
Indicator
USB
Charge
Indicator
Battery Charge Indicator for AA, AAA, C, D
Battery Charge Indicator for 9V
