Page 10
CCRadio2E
Getting Started
DISPLAY SYMBOLS
BATTERY REPLACEMENT
The battery indicator will display the battery level for approximately one
second when the radio is switched off. After removing dead batteries for
replacement, you have approximately three minutes to replace the
batteries before your clock and memory information will be lost (if the
radio is not plugged in).
This symbol means
the batteries are full.
This symbol means
the batteries are low.
This symbol flashing
means the batteries
need replacing.
INSTALLING THE BATTERIES
1) Position the radio face down on a soft surface to protect it.
2) Remove the battery compartment cover.
3) Insert the (4) “D” cell batteries into the compartment as indicated in the
drawing below. Be sure the negative(-) end is against the spring. Refer
to the drawing below to insure correct installation of your batteries.
4) Replace the battery cover. You are now ready to operate your radio.
Remove Battery Cover by pressing
both clips at the same time towards
the bottom of the radio.
AC Power Cord
plugs in here.
